How to use a reciprocating shaver

The high-speed motor of the reciprocating shaver provides powerful power, and the fast-rotating motor drives the swaying blades to shave easily and quickly.
The reciprocating shaver uses a motor to generate strong power, and then the motor drives the blade that swings from side to side to cut off the hair and beard that touches the surface of the blade. Under normal circumstances, the beard is rarely pulled. Rotary shavers also use an electric motor to drive the blade to rotate, and after the blade rotates, the beard will be shaved. Although the reciprocating shaver does not have the phenomenon of pulling, it vibrates greatly during use, and the service life of the cutter head is not long, while the rotary shaver has little vibration and long service life of the cutter head. Shaving large areas, rotary shavers are suitable for shaving small areas.
How to use a reciprocating shaver
Place the razor on the face with one hand, but the angle should be adjusted well, preferably at 90 degrees to the skin, and the other hand can stretch the skin on the face, the direction and the growth of the beard In the opposite direction, this will result in a straight-line shave.
If you choose dry shaving when you shave, be sure to not wash your face before shaving, that is to say, make sure to shave before washing your face. If you choose to shave wet, you can use a small amount first Moisturize your skin, especially the beard, you can also choose to apply a small amount of shaving foam or gel. After you are ready, before you start shaving, rinse the razor head with water from the faucet. The razor glides better on the face to help you get a clean shave. Remember to rinse the shaver multiple times during use, and remove the beard residue on the shaver in time, which can greatly ensure the smoothness of the shaver and help you shave cleanly on your face.
How reciprocating shavers work
The reciprocating shaver uses a DC motor to drive the blade to reciprocate against the steel mesh to cut off the beard embedded in the steel mesh. As for the three sets of coils in the motor, they must be wound in the same direction, and each set of turns has the same number of turns. Not bad.
The disadvantage of the reciprocating type is that the vibration of the shaver is obvious and the noise is relatively large, which is related to the high-speed motor used and the movement of the blade. The speed of the reciprocating motor is generally much faster than that of the rotary type, and the worst can reach 6800 revolutions per minute and the blade only swings from side to side, which is different from the 360-degree rotation of the rotary razor head.